Search results
Results from the WOW.Com Content Network
1.0 mm – 0.03937 inches or 5/127 (exactly) 1.0 mm – side of a square of area 1 mm²; 1.0 mm – diameter of a pinhead; 1.5 mm – average length of a flea [27] 2.54 mm – distance between pins on old dual in-line package (DIP) electronic components; 5 mm – length of an average red ant; 5 mm – diameter of an average grain of rice
The maximum force achieved by weight lifters during a 'clean and jerk' lift [18] (During the clean part) 9 kN The bite force of one adult American alligator [19] 10 4 N 16.5 kN The bite force of a 5.2 m (17 ft) saltwater crocodile [20] 18 kN The estimated bite force of a 6.1 m (20 ft) adult great white shark [21] 25 kN
The pound-force is equal to the gravitational force exerted on a mass of one avoirdupois pound on the surface of Earth.Since the 18th century, the unit has been used in low-precision measurements, for which small changes in Earth's gravity (which varies from equator to pole by up to half a percent) can safely be neglected.
Units for other physical quantities are derived from this set as needed. In English Engineering Units, the pound-mass and the pound-force are distinct base units, and Newton's Second Law of Motion takes the form = where is the acceleration in ft/s 2 and g c = 32.174 lb·ft/(lbf·s 2).
Units of force newton dyne kilogram-force, kilopond pound-force poundal; 1 N ≡ 1 kg⋅m/s 2 = 10 5 dyn:
Systems of measure either define mass and derive a force unit or define a base force and derive a mass unit [1] (cf. poundal, a derived unit of force in a mass-based system). A slug is defined as a mass that is accelerated by 1 ft/s 2 when a net force of one pound (lbf) is exerted on it. [2]
The kayser (K) is a unit of wavenumber equal to 1 cm −1 (100 m −1). The gal (Gal) is a unit of acceleration equal to 1 cm/s 2. [3] The dyne (dyn) is a unit of force equal to 1 g⋅cm⋅s −2 (10 μN). [3] The barye (Ba) is a unit of pressure equal to 1 dyn⋅cm −2 (100 mPa). The erg (erg) is a unit of energy equal to 1 dyn⋅cm (100 nJ). [3]
In unit systems where force is a derived unit, like in SI units, g c is equal to 1. In unit systems where force is a primary unit, like in imperial and US customary measurement systems , g c may or may not equal 1 depending on the units used, and value other than 1 may be required to obtain correct results. [ 2 ]