Search results
Results from the WOW.Com Content Network
The FAA states "The height–velocity diagram or H/V curve is a graph charting the safe/unsafe flight profiles relevant to a specific helicopter. As operation outside the safe area of the chart can be fatal in the event of a power or transmission failure it is sometimes referred to as the dead man's curve."
angle of attack α: angle between the x w,y w-plane and the aircraft longitudinal axis and, among other things, is an important variable in determining the magnitude of the force of lift; When performing the rotations described earlier to obtain the body frame from the Earth frame, there is this analogy between angles: β, ψ (sideslip vs yaw)
θ is the angle at which the projectile is launched; y 0 is the initial height of the projectile; If y 0 is taken to be zero, meaning that the object is being launched on flat ground, the range of the projectile will simplify to: =
Here they know the approximate range to the target and so can read off the angle (+ quick calculation) to give the left/right corrections in meters. A mil is a meter at a range of one thousand meters (for example, to move the impact of an artillery round 100 meters by a gun firing from 3 km away, it is necessary to shift the direction by 100/3 ...
An F/A-18 taking off from an aircraft carrier An Embraer E175 taking off. Takeoff is the phase of flight in which an aerospace vehicle leaves the ground and becomes airborne. For aircraft traveling vertically, this is known as liftoff.
The stalling angle of attack is less in ground effect, by approximately 2–4 degrees, than in free air. [23] [24] When the flow separates there is a large increase in drag. If the aircraft overrotates on take-off at too low a speed the increased drag can prevent the aircraft from leaving the ground.
The on-ground angle of attack of the wing has to be established during the design phase. The main and nose-gear leg lengths are chosen to give a negative angle of attack relative to the ground. This ensures the wing will have negative lift until the pilot rotates the aircraft to a positive angle of attack. During landing, the reverse happens ...
The rates of change of lift and drag with angle of attack (AoA) are called respectively the lift and drag coefficients C L and C D. The varying ratio of lift to drag with AoA is often plotted in terms of these coefficients. For any given value of lift, the AoA varies with speed. Graphs of C L and C D vs. speed are referred to as drag curves ...