Search results
Results from the WOW.Com Content Network
Vapour pressure-deficit, or VPD, is the difference (deficit) between the amount of moisture in the air and how much moisture the air can hold when it is saturated. Once air becomes saturated, water will condense to form clouds, dew or films of water over leaves. It is this last instance that makes VPD important for greenhouse regulation. If a ...
The dew point temperature equals the air temperature when the air is saturated with water; in all other cases the dew point will be less than the air temperature. [ 6 ] : 129 In technical terms, the dew point is the temperature at which the water vapor in a sample of air at constant barometric pressure condenses into liquid water at the same ...
The main feature of thermodynamic diagrams is the equivalence between the area in the diagram and energy. When air changes pressure and temperature during a process and prescribes a closed curve within the diagram the area enclosed by this curve is proportional to the energy which has been gained or released by the air.
A saturation dome uses the projection of a P–v–T diagram (pressure, specific volume, and temperature) onto the P–v plane. The points that create the left-hand side of the dome represent the saturated liquid states, while the points on the right-hand side represent the saturated vapor states (commonly referred to as the “dry” region).
Displacement ventilation systems supply air directly to the occupied zone.The air is supplied at low velocities to cause minimal induction and mixing. This system is used for ventilation and cooling of large high spaces, such as auditorium and atria, where energy may be saved if only the occupied zone is treated rather than trying to control the conditions in the entire space.
V – ventilation – the air that reaches the alveoli; Q – perfusion – the blood that reaches the alveoli via the capillaries; The V/Q ratio can therefore be defined as the ratio of the amount of air reaching the alveoli per minute to the amount of blood reaching the alveoli per minute—a ratio of volumetric flow rates.
The saturated liquid curve is the curve separating the subcooled liquid state and the two-phase state in the T–s diagram. [1] When used in a power cycle, the fluid expansion depends strongly on the nature of this saturation curve: A "wet" fluid shows a negative saturation vapor curve.
The above expression for vapor quality can be expressed as: = where is equal to either specific enthalpy, specific entropy, specific volume or specific internal energy, is the value of the specific property of saturated liquid state and is the value of the specific property of the substance in dome zone, which we can find both liquid and vapor .