Search results
Results from the WOW.Com Content Network
A brace and bit can be used to drill wider and deeper holes than can a geared hand-powered drill. The cost of the greater torque is lower rotational speed; it is easy for a geared hand drill to achieve a rotational speed of several hundred revolutions per minute , while it would require considerable effort to achieve even 100 rpm with a brace.
The gimlet bit is intended to be used in a hand brace for drilling into wood. It is the usual style of bit for use in a brace for holes below about 7 mm (0.28 in) diameter. The tip of the gimlet bit acts as a tapered screw, to draw the bit into the wood and to begin forcing aside the wood fibers, without necessarily cutting them.
A gimlet is a hand tool for drilling small holes, mainly in wood, without splitting. It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other". [1] A gimlet is always a small tool.
A popular use of hand-held power drills is to set screws into wood, through the use of screwdriver bits. Drills optimized for this purpose have a clutch to avoid damaging the slots on the screw head. Pistol-grip drill – the most common hand-held power drill type. Right-angle drill – used to drill or drive screws in tight spaces.
A typical lag screw can range in diameter from 4 to 20 mm or #10 to 1.25 in (4.83 to 31.75 mm), and lengths from 16 to 200 mm or 1 ⁄ 4 to 6 in (6.35 to 152.40 mm) or longer, with the coarse threads of a wood-screw or sheet-metal-screw threadform (but larger).
Pocket screws have a wide washer head to spread the load for a firm bond, and prevent screwing too far into the joint and cracking the wood. The self tapping screws will grip any type of wood, but coarse threads are needed for softer wood and fine threads are needed for harder. [5]
Wood screws are a common type of screw in furniture. A furniture screw can refer to any type of screw (and sometimes nut) used on furniture. Different types of screws have different uses in furniture. [1] According to a 1986 article in New York Times, screws on old furniture can be difficult to remove due to rust. [2]
A drill bushing, also known as a jig bushing, [1] is a tool used in metalworking jigs to guide cutting tools, most commonly drill bits. Other tools that are commonly used in a drill bushing include counterbores, countersinks, and reamers. They are designed to guide, position, and support the cutting tool. [2]