Ads
related to: amp for dt880 600 ohm cable box with 3 differentcrutchfield.com has been visited by 100K+ users in the past month
- 4-Channel Amps
Power Front and Rear Speakers or
a Single Set of Speakers and a Sub
- Headphone Amps
Add a Headphone Amp to Get the Best
Possible Sound from Your Headphones
- Car Amplifiers
Our Full Lineup of Car Amplifiers
from Mono Amps to 8-Channel Amps
- Home Amplifiers
Deliver Clean Power to Your Home
Speakers in One or More Rooms
- 4-Channel Amps
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Note that the wires in the 6-wire cable are coloured with two colours in a ratio of four to one in length, with the first colour mentioned being the predominant one, e.g. if the indicated colour of the wire is W-B then the wire will be coloured white for 12 mm, then blue for 3 mm and so on.
Its impedance at audio frequencies, and especially at the more restricted telephone band frequencies, is far from constant. It is possible to manufacture this kind of cable to have a 600 Ω characteristic impedance but it will only be this value at one specific frequency. This might be quoted as a nominal 600 Ω impedance at 800 Hz or 1 kHz.
Jerrold Electronics was an American provider of cable television equipment, including subscriber converter boxes, distribution network equipment (amplifiers, multitap outlets), and headend equipment in the United States.
For example, if two identical amplifiers (each rated for operation into 4 ohm) are paralleled into a 4 ohm load, each amplifier sees an equivalent of 8 ohm since the output current is now shared by both amplifiers — each amplifier supplies half the load current, and the dissipation per amplifier is halved.
The Ampeg SVT is a bass guitar amplifier designed by Bill Hughes and Roger Cox for Ampeg and introduced in 1969. The SVT is a stand-alone amplifier or "head" as opposed to a "combo" unit comprising amp and speaker(s) in one cabinet, and was capable of 300 watts output at a time when most amplifiers could not exceed 100 watts output, making the SVT an important amp for bands playing music ...
To match the impedances, both cables must be connected to a matching transformer with a turns ratio of 2:1. In this example, the 300-ohm line is connected to the transformer side with more turns; the 75-ohm cable is connected to the transformer side with fewer turns. The formula for calculating the transformer turns ratio for this example is:
The new box costs $5 per month for 12 months or you can buy it outright for $60. If you’re keeping the box longer than that, it’s smarter to buy. If you’re keeping the box longer than that ...
To accommodate these instruments, active direct boxes were designed containing powered electronic circuitry which increased the input impedance to above 1,000,000 ohms. In 1975, a 48-volt phantom powered active direct box was designed for Leon Russell 's recording studio, its circuitry published in the April 1975 edition of dB , the sound ...
Ads
related to: amp for dt880 600 ohm cable box with 3 differentcrutchfield.com has been visited by 100K+ users in the past month
walmart.com has been visited by 1M+ users in the past month