Search results
Results from the WOW.Com Content Network
2. Confirm the listed modem and location. 3. Click Next. 4. From the Dialing Options screen, check the box labeled, “I have to dial this number to turn off call waiting". 5. Confirm the proper code is listed. For most telephone services, this code is *70.
If you're using broadband (cable) internet and you can't connect, try the following troubleshooting steps in the order listed until you get up and running again. 1. Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using.
An active internet connection is required to be able to access all the best that America Online® offers. If you're using dial-up internet and can't connect, try the following troubleshooting steps: Check the dial tone - If you DO have one, it's likely the problem has something to do with your computer. If you DON'T, it's likely the problem has ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
Three network interface widgets (2 Ethernet and 1 WiFi) showing two network interfaces being up, one being down with no cable plugged in (hence: "no carrier"), underlined in red. NO CARRIER (capitalized) is a word code transmitted from a modem to its attached device (typically a computer ), indicating the modem is not (or no longer) connected ...
Download time may take 10-15 minutes over dial-up. Call 1-888-265-5555 to order a CD for faster installation.
The communications device class is used for computer networking devices akin to a network card, providing an interface for transmitting Ethernet or ATM frames onto some physical media. It is also used for modems, ISDN, fax machines, and telephony applications for performing regular voice calls.
2. Click the Network icon. 3. Click the Location drop-down menu to open it, and then select New Location by clicking it. 4. In the Name your new location box, type Test, and then click OK. 5. Click the PPP tab. 6. In the Telephone Number box, type a local access number, and then click Apply Now. 7. On the menu bar, click the phone icon, and ...