Search results
Results from the WOW.Com Content Network
The Radio Resource Control (RRC) protocol is used in UMTS, LTE and 5G on the Air interface. It is a layer 3 (Network Layer) protocol used between UE and Base Station. This protocol is specified by 3GPP in TS 25.331 [2] for UMTS, in TS 36.331 [3] for LTE and in TS 38.331 [4] for 5G New Radio. RRC messages are transported via the PDCP-Protocol.
The Radio Network Controller (RNC) is a governing element in the UMTS radio access network and is responsible for controlling the Node Bs that are connected to it. The RNC carries out radio resource management, some of the mobility management functions and is the point where encryption is done before user data is sent to and from the mobile.
Packet Data Convergence Protocol (PDCP) is specified by 3GPP in TS 25.323 [1] for UMTS, TS 36.323 [2] for LTE and TS 38.323 [3] for 5G. PDCP is located in the Radio Protocol Stack in the UMTS/LTE/5G air interface on top of the RLC layer. PDCP provides its services to the RRC and user plane upper layers, e.g. IP at the UE or to the relay at the ...
All 5G wireless devices in a cell communicate by radio waves with a cellular base station via fixed antennas, over frequencies assigned by the base station. The base stations, termed nodes, are connected to switching centers in the telephone network and routers for Internet access by high-bandwidth optical fiber or wireless backhaul connections.
Dynamic RRM schemes adaptively adjust the radio network parameters to the traffic load, user positions, user mobility, quality of service requirements, base station density, etc. Dynamic RRM schemes are considered in the design of wireless systems, in view to minimize expensive manual cell planning and achieve "tighter" frequency reuse patterns, resulting in improved system spectral efficiency.
The UE (User Equipment) interface of the RAN (Radio Access Network) primarily consists of RRC (Radio Resource Control), PDCP (Packet Data Convergence Protocol), RLC (Radio Link Control) and MAC (Media Access Control) protocols. RRC protocol handles connection establishment, measurements, radio bearer services, security and handover decisions.
Convergence is the state of a set of routers that have the same topological information about the internetwork in which they operate. For a set of routers to have converged, they must have collected all available topology information from each other via the implemented routing protocol, the information they gathered must not contradict any other router's topology information in the set, and it ...
In the context of Control reconfiguration, a field of fault-tolerant control within control engineering, reconfigurability is a property of faulty systems meaning that the original control goals specified for the fault-free system can be reached after suitable control reconfiguration.