Search results
Results from the WOW.Com Content Network
The density of quartz is around 2.65 g/cm 3 but the (dry) bulk density of a mineral soil is normally about half that density, between 1.0 and 1.6 g/cm 3. In contrast, soils rich in soil organic carbon and some friable clays tend to have lower bulk densities ( <1.0 g/cm 3 ) due to a combination of the low-density of the organic materials ...
where is the void ratio, is the porosity, V V is the volume of void-space (gases and liquids), V S is the volume of solids, and V T is the total (or bulk) volume. This figure is relevant in composites , in mining (particular with regard to the properties of tailings ), and in soil science .
Ceramic Raschig rings.....and plastic Białecki rings of increased SSA. Values obtained for specific surface area depend on the method of measurement. In adsorption based methods, the size of the adsorbate molecule (the probe molecule), the exposed crystallographic planes at the surface and measurement temperature all affect the obtained specific surface area. [4]
where is the volume fraction of the fibers in the composite (and is the volume fraction of the matrix).. If it is assumed that the composite material behaves as a linear-elastic material, i.e., abiding Hooke's law = for some elastic modulus of the composite and some strain of the composite , then equations 1 and 2 can be combined to give
In order to specify this behaviour, the initial void ratio, , and the maximum void ratio, , of the material must be entered as general parameters. As soon as the volume change results in a state of maximum void, the mobilised dilatancy angle, ψ m {\displaystyle \psi _{m}} , is automatically set back to zero.
By using plastic filler, manufacturers can save production costs as well as raw materials. Undeniably the importance of filler masterbatch in improving the physical properties of plastics, especially minimizing cost and production efficiency. With the advantage of price and stability, plastic filler supports the production of: Blow molding
Approximate specific stiffness for various materials. No attempt is made to correct for materials whose stiffness varies with their density. Material Young's modulus Density (g/cm 3) Young's modulus per density; specific stiffness (10 6 m 2 s −2) Young's modulus per density squared (10 3 m 5 kg −1 s −2) Young's modulus per density cubed ...
The Drucker–Prager yield criterion [1] is a pressure-dependent model for determining whether a material has failed or undergone plastic yielding. The criterion was introduced to deal with the plastic deformation of soils. It and its many variants have been applied to rock, concrete, polymers, foams, and other pressure-dependent materials.