enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flux (metallurgy) - Wikipedia

   en.wikipedia.org/wiki/Flux_(metallurgy)

   Rosin used as flux for soldering A flux pen used for electronics rework Multicore solder containing flux Wire freshly coated with solder, held above molten rosin flux. In metallurgy, a flux is a chemical reducing agent, flowing agent, or purifying agent.

3. Solder ring fitting - Wikipedia

   en.wikipedia.org/wiki/Solder_ring_fitting

   To obtain functional joints, the inside of the fitting and the outside of the copper pipe are cleaned using steel wool or cleaning tape, flux paste is applied, the pipe is inserted into the fitting and heat is applied from a portable butane torch or propane torch until a ring of solder shows at the edges of the fitting. To obtain a durable ...

4. Reflow soldering - Wikipedia

   en.wikipedia.org/wiki/Reflow_soldering

   Reflow soldering is a process in which a solder paste (a sticky mixture of powdered solder and flux) is used to temporarily attach anywhere from one to thousands of tiny electrical components to their contact pads, after which the entire assembly is subjected to controlled heat. The solder paste reflows in a molten state, creating permanent ...

5. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Both the male and female ends of the pipe or pipe connectors are cleaned thoroughly then coated with flux to make sure there is no surface oxide and to ensure that the solder will bond properly with the base metal. The joint is then heated using a torch, and solder is melted into the connection. When the solder cools, it forms a very strong ...

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

7. Stencil printing - Wikipedia

   en.wikipedia.org/wiki/Stencil_Printing

   The stencil printing function is achieved through a single material namely solder paste which consists of solder metal and flux. Paste also acts as an adhesive during component placement and solder reflow. The tackiness of the paste enables the components to stay in place.