enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oscillating multi-tool - Wikipedia

   en.wikipedia.org/wiki/Oscillating_multi-tool

   A non-symmetric scraper blade for an oscillating power tool Saw blade for an oscillating power tool. Various attachments and blades are on the market, giving these machines a wide variety of uses. The blades can be separated into 5 main categories: cutting; tile, grout and masonry; sanding; scraping; and polishing.

3. Thread pitch gauge - Wikipedia

   en.wikipedia.org/wiki/Thread_pitch_gauge

   A thread gauge, [1] also known as a screw gauge [2] or pitch gauge, [3] is used to measure the pitch or lead of a screw thread. Thread pitch gauges are used as a reference tool in determining the pitch of a thread that is on a screw or in a tapped hole. This tool is not used as a precision measuring instrument, rather it allows the user to ...

4. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   The lower image is a plain plug gauge used to check the size of a hole; the green end is the go, and the red end is the no-go. The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance .

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

6. Micrometer (device) - Wikipedia

   en.wikipedia.org/wiki/Micrometer_(device)

   Pitch-diameter micrometers (aka thread mics) have a matching set of thread-shaped tips for measuring the pitch diameter of screw threads. Limit mics have two anvils and two spindles, and are used like a snap gauge. The part being checked must pass through the first gap and must stop at the second gap in order to be within specification.

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.