enow.com Web Search

  1. Ad

    related to: cat5 patch panel diagram

Search results

  1. Results from the WOW.Com Content Network
  2. Patch panel - Wikipedia

    en.wikipedia.org/wiki/Patch_panel

    A patch panel is a device or unit featuring a number of jacks, usually of the same or similar type, for the use of connecting and routing circuits for monitoring, interconnecting, and testing circuits in a convenient, flexible manner.

  3. Category 5 cable - Wikipedia

    en.wikipedia.org/wiki/Category_5_cable

    Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]

  4. Structured cabling - Wikipedia

    en.wikipedia.org/wiki/Structured_cabling

    Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

  5. Ethernet crossover cable - Wikipedia

    en.wikipedia.org/wiki/Ethernet_crossover_cable

    For most optical fiber variants of Ethernet, fibers are used in pairs with one fiber for each direction. The transmitter on one end of the connection needs to be connected to the receiver on the other and vice versa. For this, fiber patch cables with duplex connectors are normally configured as crossover as is the on-premises wiring.

  6. Patch cable - Wikipedia

    en.wikipedia.org/wiki/Patch_cable

    The patch panel is a flat panel of audio connectors where XLR cables (often both "male" and "female") and 1/4 inch jacks can be plugged in. The "snake" cable makes setup more convenient, because if a sound engineer did not have a "snake", she or he would have to run 20 or 30 individual microphone and instrument cables from the stage to the ...

  7. Keystone module - Wikipedia

    en.wikipedia.org/wiki/Keystone_module

    A keystone module for a CAT5 network cable A 3-port keystone wall plate. A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel.

  8. British telephone socket - Wikipedia

    en.wikipedia.org/wiki/British_telephone_socket

    The most common type uses Category 5 cables (four twisted pairs with 100 ohm impedance) between 8P8C (colloquially and incorrectly called RJ45) room sockets and a central patch panel. The A and B wires of an analogue phone line appear in a structured cabling system usually on the centre pins of the 8P8C connector (pins 4 and 5; the blue/white ...

  9. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    The micro ribbon connector, first made by Amphenol, that is used in the RJ21 interface, has also been used to connect Ethernet ports in bulk from a switch with 50-pin ports to a Cat-5 rated patch panel, or between two patch panels. A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a ...

  1. Ad

    related to: cat5 patch panel diagram