enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Subaru Alcyone SVX - Wikipedia

   en.wikipedia.org/wiki/Subaru_Alcyone_SVX

   A single 2.5-inch (64 mm) exhaust pipe exited the main converter and went into a resonator, and onto the main, transverse, single-inlet muffler with twin exhaust tips in the bumper. The SVX was offered solely with an automatic transmissions, as Subaru did not offer a manual transmission capable of handling the horsepower and torque of the EG33 ...

3. EIAJ connector - Wikipedia

   en.wikipedia.org/wiki/EIAJ_connector

   This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input).. Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter.

4. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   The lower image is a plain plug gauge used to check the size of a hole; the green end is the go, and the red end is the no-go. The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance .

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Most threaded-pipe systems require strategically located pipe-union fittings in final assembly. The threaded pipe is heavy and requires adequate attachment to support its weight. To ensure a comprehensive pressure test, it is crucial to explicitly request a 3.1 certificate in accordance with EN HFF 10204:2004.

6. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   Generic plugs are often named for the pin diameter they are designed to take. Many non-proprietary co-axial power plugs are 5.5 mm (0.22 in) in outside diameter (OD) and 9.5 mm (0.37 in) in length. Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match.

7. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...