enow.com Web Search

  1. Ads

    related to: 1 inch to 15mm reducer size

Search results

  1. Results from the WOW.Com Content Network
  2. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

  3. Wafer (electronics) - Wikipedia

    en.wikipedia.org/wiki/Wafer_(electronics)

    The size of wafers for photovoltaics is 100–200 mm square and the thickness is 100–500 μm. [10] Electronics use wafer sizes from 100 to 450 mm diameter. The largest wafers made have a diameter of 450 mm, [ 11 ] but are not yet in general use.

  4. Caliber conversion device - Wikipedia

    en.wikipedia.org/wiki/Caliber_conversion_device

    Cartridge adapters have also been made to use .38 caliber handgun cartridges with bullet diameters of approximately .357-inch (9.1 mm) in .35 caliber rifles designed for bullets of .358-inch (9.1 mm) diameter. [3] Supplemental chambers in .22 caliber, and potentially .17 caliber as well, pose a special problem not shared by larger calibers.

  5. List of scale model sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_scale_model_sizes

    Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm An historic size for ships, also used for rockets and spacecraft. 15 mm figure scale for wargaming is considered interchangeable with this scale. [9] 1:100: 3.048 mm

  6. Hose coupling - Wikipedia

    en.wikipedia.org/wiki/Hose_coupling

    Side view of a 1.5 to 2.5 inches (38 to 64 mm) adapter. ... including 13 mm to 52 mm for the DN 50 size, 65 mm and 75 mm for the DN 80 size, 102 mm and 110 mm for the ...

  7. Concentric reducer - Wikipedia

    en.wikipedia.org/wiki/Concentric_reducer

    A concentric reducer is used to join pipe sections or tube sections on the same axis. [1] The concentric reducer is cone -shaped, and is used when there is a shift in diameter between pipes. [ 1 ] For example, when a 1" pipe transitions into a 3/4" pipe and the top or bottom of the pipe doesn't need to remain level. [ 2 ]

  1. Ads

    related to: 1 inch to 15mm reducer size