enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Electrical characteristics of dynamic loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Electrical_characteristics...

    So much so, that differences in practice between a 16-ohm nominal impedance driver and a 4-ohm nominal impedance driver have not been important enough to adjust for. The amplifier damping factor , which is the ratio of the nominal load impedance (driver voice coil) to amplifier output impedance, is adequate in either case for well-designed ...

  3. Nominal impedance - Wikipedia

    en.wikipedia.org/wiki/Nominal_impedance

    Speakers are usually designed to operate at frequencies above their resonance, and for this reason, it is the usual practice to define nominal impedance at this minimum and then round to the nearest standard value. [23] [24] The ratio of the peak resonant frequency to the nominal impedance can be as much as 4:1. [25]

  4. Thiele/Small parameters - Wikipedia

    en.wikipedia.org/wiki/Thiele/Small_parameters

    A speaker with an efficiency of 100% (1.0) would output a watt for every watt of input. Considering the driver as a point source in an infinite baffle, at one metre this would be distributed over a hemisphere with area 2 π {\displaystyle 2\pi } m 2 for an intensity of 1 / ( 2 π ) {\displaystyle 1/(2\pi )} = 0.159155 W/m 2 .

  5. Damping factor - Wikipedia

    en.wikipedia.org/wiki/Damping_factor

    The loudspeaker's nominal load impedance (input impedance) of is usually around 4 to 8 Ω, although other impedance speakers are available, sometimes dropping as low as 1 Ω or 2 Ω. However, the impedance rating of a loudspeaker is simply a number that indicates the nominal minimum impedance of that loudspeaker over a representative portion of ...

  6. Nominal watt - Wikipedia

    en.wikipedia.org/wiki/Nominal_watt

    A loudspeaker with an 8Ω nominal impedance may exhibit actual impedances ranging from approximately 5 to 100Ω depending on frequency. In this context, the nominal wattage is the theoretical electric power that would be transferred from amplifier to speaker if the loudspeaker was actually exhibiting its nominal impedance. The actual electric ...

  7. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    Speaker wire is a passive electrical component described by its electrical impedance, Z.The impedance can be broken up into three properties which determine its performance: the real part of the impedance, or the resistance, and the imaginary component of the impedance: capacitance or inductance.

  8. West Virginia knocks off No. 3 Gonzaga 86-78 in overtime in ...

    www.aol.com/west-virginia-knocks-off-no...

    Javon Small scored five of his 31 points in overtime and Tucker DeVries added key free throws late in regulation and finished with 16 points as West Virginia beat No. 3 Gonzaga 86-78 in the Battle ...

  9. Linn Isobarik - Wikipedia

    en.wikipedia.org/wiki/Linn_Isobarik

    [1] [7] The Isobarik, like the Sara and Kan that were developed in the 1970s and 80s, was designed to work best near room boundaries. [8] Manufacturer's leaflets advise positioning of the speaker close to a rear wall and approximately 2 to 3 feet (60 to 90 cm) from corners. [4] [7] The trade-off is the less than solid stereo image. [1]