enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pneumatic valve springs - Wikipedia

   en.wikipedia.org/wiki/Pneumatic_valve_springs

   Pneumatic valve springs are metal bellows filled with compressed air [1] used as an alternative to the metal wire springs used to close valves in high-speed internal combustion engines. This system was introduced in Formula One in 1986 with the Renault EF-Type .

3. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

4. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

5. Relief valve - Wikipedia

   en.wikipedia.org/wiki/Relief_valve

   A relief valve DN25 on cooling water pipe from heat exchanger Schematic diagram of a conventional spring-loaded pressure relief valve. A relief valve or pressure relief valve (PRV) is a type of safety valve used to control or limit the pressure in a system; excessive pressure might otherwise build up and create a process upset, instrument or equipment failure, explosion, or fire.

6. Spring (device) - Wikipedia

   en.wikipedia.org/wiki/Spring_(device)

   A flat spring fixed only at one end like a cantilever, while the free-hanging end takes the load. Coil spring Also known as a helical spring. A spring (made by winding a wire around a cylinder) is of two types: Tension or extension springs are designed to become longer under load. Their turns (loops) are normally touching in the unloaded ...

7. Valve guide - Wikipedia

   en.wikipedia.org/wiki/Valve_guide

   Valve guides are typically shaped in a tube with a flare at one end. Their replacement involves removing the worn part by driving it out with a hammer and specifically-shaped punch. Installation may involve shrink-fitting , heating the cylinder head and cooling the valve guide so as to ease insertion, then driving the new guide in quickly with ...