enow.com Web Search

  1. Ads

    related to: putting a restrictor in heater system for basement drain

Search results

  1. Results from the WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure.

  3. Basement waterproofing - Wikipedia

    en.wikipedia.org/wiki/Basement_waterproofing

    The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement. The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high ...

  4. Backflow prevention device - Wikipedia

    en.wikipedia.org/wiki/Backflow_prevention_device

    Backflow prevention device. The simplest, most reliable way to provide backflow prevention is to provide an air gap.An air gap is simply an open vertical space between any device that connects to a plumbing system (like a valve or faucet) and any place where contaminated water can collect or pool.

  5. Water heat recycling - Wikipedia

    en.wikipedia.org/wiki/Water_heat_recycling

    Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...

  6. Heat trap - Wikipedia

    en.wikipedia.org/wiki/Heat_trap

    Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.

  7. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    Plumbing is any system that conveys fluids for a wide range of applications. Plumbing uses pipes, valves, plumbing fixtures, tanks, and other apparatuses to convey fluids. [1] Heating and cooling (HVAC), waste removal, and potable water delivery are among the most common uses for plumbing, but it is not limited to these applications. [2]

  8. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    In Cyprus and Israel 90 percent of homes have solar water heating systems. [3] The most basic solar thermal models are the direct-gain type, in which the potable water is directly sent into the collector. Many such systems are said to use integrated collector storage (ICS), as direct-gain systems typically have storage integrated within the ...

  9. Basement - Wikipedia

    en.wikipedia.org/wiki/Basement

    Older or cheaper systems may simply have the heating vent in the ceiling of the basement. The finished floor is typically raised off the concrete basement floor. In countries such as Canada, laminate flooring is an exception: It is typically separated from the concrete by only a thin foam underlay. Radiant heating systems may be embedded within ...

  1. Ads

    related to: putting a restrictor in heater system for basement drain