Search results
Results from the WOW.Com Content Network
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
The scheme is broken down to twelve units covering different actions and hazardous area concepts. In 2017, CompEx 01-04 was introduced to the NEC Standard. NEC500 & also NEC505, along with Ex "f" Foundation Courses.
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
The aim of Directive 2014/34/EU is to allow the free trade of ‘ATEX’ equipment and protective systems within the EU by removing the need for separate testing and documentation for each member state. The regulations apply to all equipment intended for use in explosive atmospheres, whether electrical or mechanical, including protective systems.
The Directive on the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment (2002/95/EC), [12] commonly referred to as the Restriction of Hazardous Substances Directive (RoHS Directive), was also adopted in February 2003 by the European Union. The RoHS Directive took effect on July 1, 2006, and is required ...
Electrical equipment in hazardous areas where flammable gases may be present e.g. oil refineries, petrol stations; Areas where corrosive chemicals may be present e.g. factories; Building plant rooms; Hot areas e.g. power stations, foundries, and close to or even inside industrial furnaces, kilns and ovens
Electrical injury; Electrical bonding; Electrical burn; Electrical code; Electrical equipment in hazardous areas; Electrical Safety Foundation; Electrically conducting yarn; Electrostatic discharge; EN 62262; ENEC Mark; Energy and Utility Skills; ESD turnstile; Extra-low voltage
In facilities that handle flammable gases or liquids, special rules may govern the installation and wiring of electrical equipment in hazardous areas. Wires and cables are rated by the circuit voltage, temperature rating and environmental conditions (moisture, sunlight, oil, chemicals) in which they can be used.