Search results
Results from the WOW.Com Content Network
Bioelectrical impedance analysis (BIA) is a method for estimating body composition, in particular body fat and muscle mass, where a weak electric current flows through the body, and the voltage is measured in order to calculate impedance (resistance and reactance) of the body. Most body water is stored in muscle.
Standard bioelectrical impedance analysis (BIA), like EIM, also employs a weak, high frequency electric current to measure characteristics of the human body. In standard BIA, unlike EIM, electric current is passed between electrodes placed on the hands and feet, and the impedance characteristics of the entire current path are measured.
The bioelectrical impedance analysis (BIA) method is a lower-cost (from less than one to several hundred US dollars in 2006 [16]) but less accurate way to estimate body fat percentage. The general principle behind BIA: two or more conductors are attached to a person's body and a small electric current is sent through the body.
The Samsung Bio Processor is an advanced system logic chip designed by Samsung Electronics in December 2015 that integrates five AFEs including bioelectrical impedance analysis (BIA), photoplethysmogram (PPG), electrocardiogram (ECG), skin temperature, and galvanic skin response (GSR) into a single chip that measures body fat, and skeletal muscle mass, heart rate, heart rhythm, skin ...
This technique measures the impedance of a system over a range of frequencies, and therefore the frequency response of the system, including the energy storage and dissipation properties, is revealed. Often, data obtained by electrochemical impedance spectroscopy (EIS) is expressed graphically in a Bode plot or a Nyquist plot.
Developmental bioelectricity is a sub-discipline of biology, related to, but distinct from, neurophysiology and bioelectromagnetics.Developmental bioelectricity refers to the endogenous ion fluxes, transmembrane and transepithelial voltage gradients, and electric currents and fields produced and sustained in living cells and tissues.
The term biosignal is often used to refer to bioelectrical signals, but it may refer to both electrical and non-electrical signals. The usual understanding is to refer only to time-varying signals, although spatial parameter variations (e.g. the nucleotide sequence determining the genetic code) are sometimes subsumed as well.
Another method of determining total body water percentage (TBW%) is via bioelectrical impedance analysis (BIA). In the traditional BIA method, a person lies on a cot and spot electrodes are placed on the hands and bare feet. Electrolyte gel is applied first, and then a weak current of frequency 50kHz is introduced.