Ads
related to: high positive offset wheels for a 2003 tahoe ss 4 wheeler motor rebuild
Search results
Results from the WOW.Com Content Network
Scrub radius is changed whenever there is a change in wheel offset. For example, when the wheels are pushed out from the body of the car the scrub radius becomes more positive. Older cars tended to have very close to zero scrub radius but often on the positive side, while newer cars with ABS tend to have a negative scrub radius (this is why ...
The GMT400 Tahoe was carried over into the 2000 model year as two "Limited Edition" models: the 4×2 Limited, and the 4×4 Z71. Both models were discontinued after the 2000 model year . The GMC Yukon Denali was redesigned for the 2001 model year , and the Cadillac Escalade was redesigned in 2002 (there was no Escalade for the 2001 model year ).
The GMT 400 and similar GMT 480 was the platform used for the Chevrolet C/K and GMC Sierra full-size pickup trucks beginning with the 1988 model year. [1] The GMT 410, GMT 420, GMT 425, and GMT 430 variants were derived for full-size SUVs, including the 1992–1994 Chevrolet Blazer and 1995–2000 Tahoe, and the GMC Yukon from late 1991 to 2000.
The offset is the distance from the wheel's true centerline (half the width) to the wheel's mounting surface. Offset is covered in more detail below. A typical wheel size will be listed beginning with the diameter, then the width, and lastly the offset (+ or - for positive or negative). Although wheel sizes are marketed with measurements in ...
The GMT800 was a General Motors full-size truck platform used from the 1999 through 2009 model years. It is the foundation for the Chevrolet Silverado and GMC Sierra pickups; and the derivative GMT820 and GMT830 versions for the Chevrolet Tahoe/GMC Yukon and the Chevrolet Suburban/GMC Yukon XL full-size SUVs, respectively.
The disk is welded in place such that the center of the wheel is equal to the center of the hub. The distance between the centerline of the rim and the mounting plane of the wheel is called the "offset" and can be positive, negative, or zero. [14] One-piece rim and wheel assemblies (see image) may be obtained by casting or forging.
Depending upon wheel orientation, Camber can be of three types. 1. Positive Camber The Camber would be called positive when the top of the wheels lean outwards. Positive Camber is generally used in off-road vehicles as it improves steering response and decreases steering effort. Positive Camber is also used in load-carrying vehicles.
This can be contrasted with steer, which is the antisymmetric angle, i.e. both wheels point to the left or right, in parallel (roughly). Negative toe, or toe out, is the front of the wheel pointing away from the centreline of the vehicle. Positive toe, or toe in, is the front of the wheel pointing towards the centreline of the vehicle. [2]
Ads
related to: high positive offset wheels for a 2003 tahoe ss 4 wheeler motor rebuild