enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Reciprocal frame - Wikipedia

   en.wikipedia.org/wiki/Reciprocal_frame

   The first rafter is fitted between the wall and the temporary central support and then further rafters are added, each resting on the last. The final rafter fits on top of the previous rafter and under the very first one. The rafters are then tied before the temporary support is removed.

3. Birdsmouth joint - Wikipedia

   en.wikipedia.org/wiki/Birdsmouth_joint

   A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]

4. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.

5. List of roof shapes - Wikipedia

   en.wikipedia.org/wiki/List_of_roof_shapes

   Catenary: An arched roof in the form of a catenary curve. Arched roof, bow roof, [11] Gothic, Gothic arch, and ship's bottom roof. Historically also called a compass roof. [12] [13] Circular Bell roof (bell-shaped, ogee, Philibert de l'Orme roof): A bell-shaped roof. Compare with bell-cast eaves. Domed; Onion dome or rather an imperial roof ...

6. Hammerbeam roof - Wikipedia

   en.wikipedia.org/wiki/Hammerbeam_roof

   A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.

7. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple. Depending on the roof covering material, either horizontal laths , battens , or purlins are fixed to the rafters; or boards, plywood , or oriented strand board form the roof deck (also called the sheeting or ...

8. Soffit - Wikipedia

   en.wikipedia.org/wiki/Soffit

   Its archetypal form, sometimes incorporating or implying the projection of rafters or trusses over the exterior of supporting walls, is the underside of eaves (to connect a supporting wall to projecting edge(s) of the roof). The vertical band at the edge of the roof is called a fascia. A soffit of an arch is frequently called an intrados.

9. Timber roof truss - Wikipedia

   en.wikipedia.org/wiki/Timber_roof_truss

   Pairs of opposing rafters were thus initially tied together by a horizontal tie beam, to form coupled rafters. But such roofs were structurally weak, and lacking any longitudinal support, they were prone to racking, a collapse resulting from horizontal movement. Timber roof trusses were a later, medieval development. [2] A roof truss is cross ...