Search results
Results from the WOW.Com Content Network
A sectional chart is a two-sided chart created from a Lambert Conformal Conic Projection [1] with two defined standard parallels. The scale is 1:500,000, with a contour interval of 500 feet. The size of each sectional is designed to be "arm's width" when completely unfolded.
[2] The first sectional chart was published in 1930; in 1937 the full series of the lower 48 states was completed. These early sectional charts were smaller (most covered two degrees of latitude and six of longitude) with the map on one side; after 1950 the legend and index to adjoining charts was on the reverse.
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
A World Aeronautical Chart (WAC) was a type of aeronautical chart used for navigation by pilots of moderate speed aircraft and aircraft at high altitudes in the United States. They are at a scale of 1:1,000,000 (about 1 inch = 13.7 nautical miles or 16 statute miles).
The MEF on Canadian VFR navigation charts is calculated by taking the higher value of: the top elevation of the highest obstacle plus the vertical accuracy (a variable number of feet) of the terrain source data; or; the elevation of the highest terrain plus 328 feet plus the vertical accuracy variable of the terrain source data. [1]
Changing a wheel on a Lockheed P-3 Orion aircraft Tires on the wheels of a bogie on a Boeing 777. An aircraft tire or tyre is designed to withstand extremely heavy loads for short durations. [1] The number of tires required for aircraft increases with the weight of the aircraft, as the weight of the airplane needs to be distributed more evenly.
The width of the airway beyond 51 NM from a navaid is 4.5 degrees on either side of the centerline (at 51 NM from a navaid, 4.5 degrees from the centerline of a radial is equivalent to 4 NM). The maximum width of the airway is at a designated changeover point between the two navaids, usually half way.
A prohibited airspace is an area (volume) of airspace within which flight of aircraft is not allowed, usually due to security concerns. It is one of many types of special use airspace designations and is depicted on aeronautical charts with the letter "P" followed by a serial number.