Search results
Results from the WOW.Com Content Network
A single connector must be used for each signal. SCART: Consumer electronics, mostly in Europe. Carries analog stereo sound, along with composite video and/or RGB video. Some devices also support S-Video, which shares the same pins as composite video and RGB. YP B P R is also sometimes supported as a non-standard extension via the RGB pins. D ...
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
VGA section on the motherboard in IBM PS/55. The color palette random access memory (RAM) and its corresponding digital-to-analog converter (DAC) were integrated into one chip (the RAMDAC) and the cathode-ray tube controller was integrated into a main VGA chip, which eliminated several other chips in previous graphics adapters, so VGA only additionally required external video RAM and timing ...
Previous HDMI versions use three data channels (each operating at up to 6.0 Gbit/s in HDMI 2.0, or up to 3.4 Gbit/s in HDMI 1.4), with an additional channel for the TMDS clock signal, which runs at a fraction of the data channel speed (one tenth the speed, or up to 340 MHz, for signaling rates up to 3.4 Gbit/s; one fortieth the speed, or up to ...
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
More recent operating systems do not use the BIOS interrupt calls after startup. [4] Most BIOS implementations are specifically designed to work with a particular computer or motherboard model, by interfacing with various devices especially system chipset. Originally, BIOS firmware was stored in a ROM chip on the PC
Inside external display devices there is a controller board that will convert the video signal using color mapping and image scaling usually employing the discrete cosine transform (DCT) in order to convert any video source like CVBS, VGA, DVI, HDMI, etc. into digital RGB at the native resolution of the display panel. In a laptop the graphics ...
The motherboard of an early microcomputer, the Microtan 65, showing the silver-cased ASTEC 1111EM36 UHF TV modulator at top left. Prior to the introduction of specialised video connector standards such as SCART, TVs were designed to only accept signals through the aerial connector: signals originate at a TV station, are transmitted over the air, and are then received by an antenna and ...