Search results
Results from the WOW.Com Content Network
The modern toilet utilises a cistern to reserve and hold the correct amount of water required to flush the toilet bowl. In earlier toilets, the cistern was located high above the toilet bowl and connected to it by a long pipe. It was necessary to pull a hanging chain connected to a release valve located inside the cistern in order to flush the ...
Effluent sewer systems, also called septic tank effluent drainage (STED) or solids-free sewer (SFS) systems, have septic tanks that collect sewage from residences and businesses, and the effluent that comes out of the tank is sent to either a centralized sewage treatment plant or a distributed treatment system for further treatment. Most of the ...
An elbow is installed between two lengths of pipe (or tubing) to allow a change of direction, usually a 90° or 45° angle; 22.5° elbows are also available. The ends may be machined for butt welding, threaded (usually female), or socketed. When the ends differ in size, it is known as a reducing (or reducer) elbow.
In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...
This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...
This may be the flushing sort, which is plumbed into a cistern (tank) operated by a ballcock (float valve). Or it may be a dry model, which does not need water. The toilet room may also include a plunger, a rubber or plastic tool mounted on a handle, which is used to remove blockages from the toilet drain. Toilets often have a wall mirror above ...
This system is suitable for locations plumbed with 12.7 or 9.5 mm (1 ⁄ 2 or 3 ⁄ 8 inch) water pipes which cannot supply water quickly enough to flush the toilet; the tank is needed to supply a large volume of water in a short time. The tank typically collects between 6 and 17 L (1.6 and 4.5 US gallons) of water over a period of time.
For this reason, the UK domestic water system has traditionally (prior to 1989) employed a "cistern feed" system, where the incoming supply is connected to the kitchen sink and also a header/storage tank in the attic. Water can dribble into this tank through a 12 mm pipe, plus ball valve, and then supply the house on 22 or 28 mm pipes.