Search results
Results from the WOW.Com Content Network
The Fermi level does not necessarily correspond to an actual energy level (in an insulator the Fermi level lies in the band gap), nor does it require the existence of a band structure. Nonetheless, the Fermi level is a precisely defined thermodynamic quantity, and differences in Fermi level can be measured simply with a voltmeter.
The mass action law defines a quantity called the intrinsic carrier concentration, which for undoped materials: n i = n 0 = p 0 {\displaystyle n_{i}=n_{0}=p_{0}} The following table lists a few values of the intrinsic carrier concentration for intrinsic semiconductors , in order of increasing band gap.
E i: The intrinsic Fermi level may be included in a semiconductor, to show where the Fermi level would have to be for the material to be neutrally doped (i.e., an equal number of mobile electrons and holes). E imp: Impurity energy level. Many defects and dopants add states inside the band gap of a semiconductor or insulator. It can be useful to ...
The characteristic energy level up to which the electrons have filled is called the Fermi level. The position of the Fermi level with respect to the band structure is very important for electrical conduction: Only electrons in energy levels near or above the Fermi level are free to move within the broader material structure, since the electrons ...
In solid-state physics, the valence band and conduction band are the bands closest to the Fermi level, and thus determine the electrical conductivity of the solid. In nonmetals, the valence band is the highest range of electron energies in which electrons are normally present at absolute zero temperature, while the conduction band is the lowest range of vacant electronic states.
At absolute zero temperature, all of the electrons have energy below the Fermi level; but at non-zero temperatures the energy levels are filled following a Fermi-Dirac distribution. In undoped semiconductors the Fermi level lies in the middle of a forbidden band or band gap between two allowed bands called the valence band and the conduction ...
The crossover from hole-dominated conduction (positive ) to electron-dominated conduction (negative ) happens for Fermi levels in the middle of the 1.1 eV-wide gap. In extrinsic (doped) semiconductors either the conduction or valence band will dominate transport, and so one of the numbers above will give the measured values.
This spacing is called the electron affinity (note that this has a different meaning than the electron affinity of chemistry); in silicon for example the electron affinity is 4.05 eV. [16] If the electron affinity E EA and the surface's band-referenced Fermi level E F-E C are known, then the work function is given by