Search results
Results from the WOW.Com Content Network
Detonation spraying has to be performed at a location specifically designed for it, as the gun is reasonable large and it is a loud process that produces substantial noise. For this reason, it is usually installed in a sound-proof room (with concrete walls 45 cm thick).
The high spray outputs and large cross-sections require the work to be mechanised. Concrete spraying systems with duplex pumps are mainly used for working with wet mixes. Unlike conventional concrete pumps, these systems have to meet the additional requirement of delivering a concrete flow that is as constant as possible, and therefore ...
Low-velocity powder-actuated tool cross section. Powder-actuated tools are often used because of their speed of operation, compared to other processes such as drilling and then installing a threaded fastener. They can more easily be used in narrow or awkward locations, such as installing steel suspension clips into an overhead concrete ceiling.
With commercial spray guns for automobiles, it is vital that the painter have a clean air source to breathe, because automotive paint is far more harmful to the lungs than acrylic. Certain spray guns, called High-Volume Low-Pressure (HVLP) spray guns, are designed to deliver the same high volumes of paint without requiring such high pressures.
Plaster spraying allows a plasterer to skim a drywall more than five times faster than using a hand float to apply it. Although classic gypsum-based plaster can be sprayed if it is "spray grade," most plaster sprayers prefer the organic-based pre-mixed plaster packaged in a plastic bag because the plaster spraying machine does not need to be cleaned out after the job is finished, providing ...
Latex paints (emulsion paints British English, not to be confused with latex rubber) are an emulsion of polymer particles dispersed in water. Macroemulsions in latex paint are inherently unstable and phase separate, so surfactants are added to lower interfacial tension and stabilize polymer particles to prevent demulsification. [7]
Diagram of spray-up process. Spray-Up also known as chop method of creating fiberglass objects by spraying short strands of glass out of a pneumatic gun. This method is used often when one side of the finished product is not seen, or when large quantities of a product must be made cheaply and quickly with moderate strength requirements. [1]
Spray nozzles can have one or more outlets; a multiple outlet nozzle is known as a compound nozzle. Multiple outlets on nozzles are present on spray balls, which have been used in the brewing industry for many years for cleaning casks and kegs. [2] Spray nozzles range from those for heavy duty industrial uses to light duty spray cans or spray ...