Search results
Results from the WOW.Com Content Network
Tracked vehicle configured as a dedicated pile driver. A pile driver is a heavy-duty tool used to drive piles into soil to build piers, bridges, cofferdams, and other "pole" supported structures, and patterns of pilings as part of permanent deep foundations for buildings or other structures. Pilings may be made of wood, solid steel, or tubular ...
A continuous flight auger drill is used to excavate a hole and concrete is injected through a hollow shaft under pressure as the auger is extracted. Reinforcement is then inserted after the auger is removed. [1] This creates a continuous pile without ever leaving an open hole.
Pressure piling is a phenomenon related to combustion of gases in a tube or long vessel. When a flame front propagates along a tube, the unburned gases ahead of the front are compressed, and hence heated. The amount of compression varies depending on the geometry and can range from twice to eight times the initial pressure.
Larssen sheet piling was developed in 1906 by Tryggve Larssen, engineer from Bremen (Germany). [ 2 ] [ 3 ] [ 4 ] Its applications include piers , oil terminals , waste storage facilities, shoreline protection, [ 5 ] bridges, houses, buildings, dry docks, other construction sites, and for the strengthening of pond banks, preventing slumping into ...
Screw piles are typically manufactured from high-strength steel [1] using varying sizes of tubular hollow sections with helical flights. The pile shaft transfers a structure's load into the pile. Helical steel plates are welded to the pile shaft to suit the site specific ground conditions. Helices can be press-formed to a specified pitch or ...
In jet piling high pressure water is used to set piles. [8] High pressure water cuts through soil with a high-pressure jet flow and allows the pile to be fitted. [9] One advantage of Jet Piling: the water jet lubricates the pile and softens the ground. [10] The method is in use in Norway. [11]
The Franki piling system (also called pressure-injected footing) is a method used to drive expanded base cast-in-situ concrete (Franki) piles. [1] It was developed by Belgian Engineer Edgard Frankignoul in 1909.
Suction caissons (also referred to as suction anchors, suction piles or suction buckets) are a form of fixed platform anchor in the form of an open bottomed tube embedded in the sediment and sealed at the top while in use so that lifting forces generate a pressure differential that holds the caisson down.