Search results
Results from the WOW.Com Content Network
Waveforms made by summing known simple waveforms have an RMS value that is the root of the sum of squares of the component RMS values, if the component waveforms are orthogonal (that is, if the average of the product of one simple waveform with another is zero for all pairs other than a waveform times itself). [5]
The root mean square acceleration (G rms) is the square root of the area under the ASD curve in the frequency domain. The G rms value is typically used to express the overall energy of a particular random vibration event and is a statistical value used in mechanical engineering for structural design and analysis purposes.
In electronics and electrical engineering, the form factor of an alternating current waveform (signal) is the ratio of the RMS (root mean square) value to the average value (mathematical mean of absolute values of all points on the waveform). [1] It identifies the ratio of the direct current of equal power relative to the given alternating ...
True RMS provides a more correct value that is proportional to the square root of the average of the square of the curve, and not to the average of the absolute value. For any given waveform , the ratio of these two averages is constant and, as most measurements are made on what are (nominally) sine waves, the correction factor assumes this ...
A diode intended for regular operation in the reverse, avalanche breakdown, mode. Used as a voltage reference, noise source, and in certain classes of microwave oscillator device. average rectified value The average value of an alternating current waveform, taking the absolute value of the waveform. The average value is generally different from ...
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels , crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios .
In fluid dynamics, normalized root mean square deviation (NRMSD), coefficient of variation (CV), and percent RMS are used to quantify the uniformity of flow behavior such as velocity profile, temperature distribution, or gas species concentration. The value is compared to industry standards to optimize the design of flow and thermal equipment ...
On the other hand the RMS describes which direct current delivers the same amount of power within the same time period. The average of a symmetric alternating value is zero and it is therefore not useful to characterize it. Thus the easiest way to determine a quantitative measurement size is to use the average rectified value.