Search results
Results from the WOW.Com Content Network
The issuance of a drawing from the engineering/design activity to the production activity. In other words, the event when a draft becomes a completed, official document. A stamp on the drawing saying "ISSUED" documents that RTP has occurred. RTV: room-temperature vulcanizing; return to vendor: 1. RTV sealants, a way to seal joints. 2.
Sign ⌀ in a technical drawing A photographic filter marked as having a 58mm thread diameter. The symbol or variable for diameter, ⌀, is sometimes used in technical drawings or specifications as a prefix or suffix for a number (e.g. "⌀ 55 mm"), indicating that it represents diameter. [3] Photographic filter thread sizes are often denoted ...
The diameter symbol is used extensively in engineering drawings, and it is also seen in situations where abbreviating "diameter" is useful, such as on camera lenses. For example, a lens with a diameter of 82 millimeters would be engraved with " ⌀ 82 mm ".
A reference dimension is a dimension on an engineering drawing provided for information only. [1] Reference dimensions are provided for a variety of reasons and are often an accumulation of other dimensions that are defined elsewhere [2] (e.g. on the drawing or other related documentation). These dimensions may also be used for convenience to ...
The post 96 Shortcuts for Accents and Symbols: A Cheat Sheet appeared first on Reader's Digest. These printable keyboard shortcut symbols will make your life so much easier.
An engineering drawing is a type of technical drawing that is used to convey information about an object. A common use is to specify the geometry necessary for the construction of a component and is called a detail drawing.
The outside diameter of a gear is the diameter of the addendum (tip) circle. In a bevel gear it is the diameter of the crown circle. In a throated worm gear it is the maximum diameter of the blank. The term applies to external gears, this is can also be known from major diameter. [1]
The diameter symbol in engineering, ⌀, is often erroneously referred to as "phi", and the diameter symbol is sometimes erroneously typeset as Φ. This symbol is used to indicate the diameter of a circular section; for example, "⌀14" means the diameter of the circle is 14 units. A clock signal in electronics is often called Phi or uses the ...