enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.

3. Lumber - Wikipedia

   en.wikipedia.org/wiki/Lumber

   As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...

4. Timber framing - Wikipedia

   en.wikipedia.org/wiki/Timber_framing

   Timber-framed structures differ from conventional wood-framed buildings in several ways. Timber framing uses fewer, larger wooden members, commonly timbers in the range of 15 to 30 cm (6 to 12 in), while common wood framing uses many more timbers with dimensions usually in the 5- to 25-cm (2- to 10-in) range.

5. Cross-laminated timber - Wikipedia

   en.wikipedia.org/wiki/Cross-laminated_timber

   Cross-laminated timber (CLT) is a subcategory of engineered wood [1] panel product made from gluing together at least three layers [2] of solid-sawn lumber (i.e. lumber cut from a single log). [3] Each layer of boards is usually oriented perpendicular to adjacent layers and glued on the wide faces of each board, usually in a symmetric way so ...

6. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Since there is no vertical load to be supported by partitions, single studs may be used at door openings. The top of the opening may be bridged with a single piece of 1 + 1 ⁄ 2 in (38 mm) lumber the same width as the studs. These members provide a nailing support for wall finish, door frames and trim. [12]

7. Parallel-strand lumber - Wikipedia

   en.wikipedia.org/wiki/Parallel-strand_lumber

   The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. Plank (wood) - Wikipedia

   en.wikipedia.org/wiki/Plank_(wood)

   The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.