enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RF power amplifier - Wikipedia

   en.wikipedia.org/wiki/RF_power_amplifier

   A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .

3. Inductive output tube - Wikipedia

   en.wikipedia.org/wiki/Inductive_output_tube

   The inductive output tube (IOT) or klystrode is a variety of linear-beam vacuum tube, similar to a klystron, used as a power amplifier for high frequency radio waves. It evolved in the 1980s to meet increasing efficiency requirements for high-power RF amplifiers in radio transmitters. [1]

4. Valve RF amplifier - Wikipedia

   en.wikipedia.org/wiki/Valve_RF_amplifier

   A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...

5. Tuner (radio) - Wikipedia

   en.wikipedia.org/wiki/Tuner_(radio)

   Marantz 2050L AM/FM stereo tuner (USA; 1978-1980) [1]. In electronics and radio, a tuner is a type of receiver subsystem that receives RF transmissions, such as AM or FM broadcasts, and converts the selected carrier frequency into a form suitable for further processing or output, such as to an amplifier or loudspeaker.

6. Traveling-wave tube - Wikipedia

   en.wikipedia.org/wiki/Traveling-wave_tube

   A traveling-wave tube (TWT, pronounced "twit" [1]) or traveling-wave tube amplifier (TWTA, pronounced "tweeta") is a specialized vacuum tube that is used in electronics to amplify radio frequency (RF) signals in the microwave range. [2]

7. Radio receiver design - Wikipedia

   en.wikipedia.org/wiki/Radio_receiver_design

   Software-defined radio (SDR) is a radio communication system where components, that have been traditionally implemented in hardware (e.g. mixers, filters, amplifiers, modulators/demodulators, detectors, etc.) are instead implemented by means of software on a personal computer or embedded system. [2]

8. Linear amplifier - Wikipedia

   en.wikipedia.org/wiki/Linear_amplifier

   Class-D amplifiers use switching technology to achieve high efficiency, often exceeding 90%, thereby requiring less power to operate, compared with that of other amplifier types. Because of the digital train used to drive the amplifier, many do not consider the Class-D amplifier a linear amplifier, yet many audio and radio manufacturers have ...

9. 807 (vacuum tube) - Wikipedia

   en.wikipedia.org/wiki/807_(vacuum_tube)

   The redesign mainly involved the omission of some of the internal RF shielding, and the substitution of a bakelite octal base for the micanol or ceramic 5-pin. In turn, these low cost sweep tube derivatives found some use as RF power amplifiers in homebrew amateur radio transmitters in the 1950s.