Search results
Results from the WOW.Com Content Network
The basic quantities describing a sphere (meaning a 2-sphere, a 2-dimensional surface inside 3-dimensional space) will be denoted by the following variables r {\displaystyle r} is the radius, C = 2 π r {\displaystyle C=2\pi r} is the circumference (the length of any one of its great circles ),
In the case of lines, the cone extends infinitely far in both directions from the apex, in which case it is sometimes called a double cone. Either half of a double cone on one side of the apex is called a nappe. The axis of a cone is the straight line passing through the apex about which the base (and the whole cone) has a circular symmetry.
A cone and a cylinder have radius r and height h. 2. The volume ratio is maintained when the height is scaled to h' = r √ π. 3. Decompose it into thin slices. 4. Using Cavalieri's principle, reshape each slice into a square of the same area. 5. The pyramid is replicated twice. 6. Combining them into a cube shows that the volume ratio is 1:3.
Cone of a circle. The original space X is in blue, and the collapsed end point v is in green.. In topology, especially algebraic topology, the cone of a topological space is intuitively obtained by stretching X into a cylinder and then collapsing one of its end faces to a point.
Cone: Tapers smoothly from a flat base (frequently, though not necessarily, circular) to a point called the apex or vertex: A right circular cone and an oblique circular cone Cylinder: Straight parallel sides and a circular or oval cross section A solid elliptic cylinder A right and an oblique circular cylinder Ellipsoid
This formula holds whether or not the cylinder is a right cylinder. [7] This formula may be established by using Cavalieri's principle. A solid elliptic right cylinder with the semi-axes a and b for the base ellipse and height h. In more generality, by the same principle, the volume of any cylinder is the product of the area of a base and the ...
The mapping cylinder is commonly used to construct the mapping cone ... An explicit formula for the strong deformation retraction can be worked out. [3]
A conic is the curve obtained as the intersection of a plane, called the cutting plane, with the surface of a double cone (a cone with two nappes).It is usually assumed that the cone is a right circular cone for the purpose of easy description, but this is not required; any double cone with some circular cross-section will suffice.