Search results
Results from the WOW.Com Content Network
Intraosseous devices allow quick and safe access to the vascular system for fluid and drug administration. After proper education and training, medical professionals can obtain vascular access via the IO route of administration by using one of the multiple devices that have been approved by the FDA for 24-hour use. [7] There are several FDA ...
An alternative method is via instruction-based I/O which requires that a CPU have specialized instructions for I/O. [1] Both input and output devices have a data processing rate that can vary greatly. [2] With some devices able to exchange data at very high speeds direct access to memory (DMA) without the continuous aid of a CPU is required. [2]
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
Established in 2001, Vidacare Corporation was the developer of intraosseous (inside the bone) medical devices. Its devices were used in vascular access, emergency and disaster medicine, oncology, and spinal surgery. Privately held, the company was based in San Antonio, Texas, and its products were marketed in over 50 countries worldwide. [2]
The first use of channel I/O was with the IBM 709 [2] vacuum tube mainframe in 1957, whose Model 766 Data Synchronizer was the first channel controller. The 709's transistorized successor, the IBM 7090, [3] had two to eight 6-bit channels (the 7607) and a channel multiplexor (the 7606) which could control up to eight channels.
In emergency situations when peripheral access cannot be easily achieved, such as in arrest scenarios, intraosseous methods can be used to gain rapid access to the venous system. These methods usually involve inserting an access device into the tibia or femur bones in the legs, humerus in the upper arm, or sometimes the sternum in the chest. [2 ...
Higher performance hardware such as graphics cards use DMA to access memory directly; in a virtual environment all memory addresses are re-mapped by the virtual machine software, which causes DMA devices to fail. The IOMMU handles this re-mapping, allowing the native device drivers to be used in a guest operating system.
GPIOs usually employ standard logic levels and cannot supply significant current to output loads. When followed by an appropriate high-current output buffer (or mechanical or solid-state relay), a GPIO may be used to control high-power devices such as lights, solenoids, heaters, and motors (e.g., fans and blowers). Similarly, an input buffer ...