Search results
Results from the WOW.Com Content Network
Superheated steam was widely used in main line steam locomotives. Saturated steam has three main disadvantages in a steam engine: it contains small droplets of water which have to be periodically drained from the cylinders; being precisely at the boiling point of water for the boiler pressure in use, it inevitably condenses to some extent in the steam pipes and cylinders outside the boiler ...
The water comes (8), and goes into pipes (9). Warmed by the combustion of the fuel (came in 3), steam bubbles forming in these pipes, and arrives in the drum (7). Then steam goes (through 6) in smaller pipes (10) and being superheated here. At last, superheated steam goes to engine room (5).
A fireless steam locomotive is similar to a conventional steam locomotive, but has a reservoir, known as a steam accumulator, instead of a boiler. This reservoir is charged with superheated water under pressure from a stationary boiler. The engine works like a conventional steam engine using the high pressure steam above the water in the ...
A superheater is a device used to convert saturated steam or wet steam into superheated steam or dry steam. Superheated steam is used in steam turbines for electricity generation, in some steam engines, and in processes such as steam reforming. There are three types of superheaters: radiant, convection, and separately fired.
The superheated steam S 3/5H class, of which thirty were built from 1906, later the DGR class 17 5. Bavaria only began using 4-6-0 passenger locomotives in 1905. The first was the P 3/5 N class, of which 36 were built, later the DRG class 38 0. After a long break, Bavaria ordered a superheated steam P 3/5 H class in 1921.
It was then generally similar to the standard engines after they had been superheated, and it ran until 1947. [11] The last ten, Nos. 1452–61 built at Doncaster in 1910, had boilers producing superheated steam at 150 lbf/in 2 (1,000 kPa), and the cylinders were fed through piston valves. [12]
German G7a(TI) torpedo at the Norwegian Armed Forces Museum in Oslo. The G7a(TI) was the standard issue Kriegsmarine torpedo introduced to service in 1934. It was a steam-powered design, using a wet heater engine burning decaline, with a range of 7,500 metres (24,600 ft) at 40 knots (74 km/h; 46 mph) speed.
In 1900, two extra engines were added to the class, Furness Railway numbers 124–125. (works numbers 4651–4652). In 1913, two engines, FR Nos. 34 and 37, were fitted with experimental Phoenix smokebox superheaters, however, these were removed the following year. At some point in time locomotives 21, 22, 34 and 35 were renumbered 44–47 ...