Search results
Results from the WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination. The sum of ...
The configuration software of choice is then used to configure the persistent configuration which is applied on boot. It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip: [10]
The no auto-summary command prevents automatic route summarization on classful boundaries, which would otherwise result in routing loops in discontiguous networks. Router# configure terminal Router(config)# router eigrp 1 Router (config-router)# network 10.201.96.0 0.0.15.255 Router (config-router)# no auto-summary Router (config-router)# exit
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.
An Interface Descriptor Block, or simply IDB, is a portion of memory or Cisco IOS internal data structure that contains information such as the IP address, interface state, and packet statistics for networking data. Cisco's IOS software maintains one IDB for each hardware interface in a particular Cisco switch or router and one IDB for each ...
The Cisco Internetwork Operating System enables network administrators to modify the distance by changing the distance value in sub-router configuration mode. In the example below, RIP's administrative distance is changed to 89 so that it used in preference to OSPF.
When a multicast packet enters a router's interface, the router looks up the list of networks that are reachable via that interface (i.e., it checks the paths by which the packet could have arrived). If the router finds a matching routing entry for the source IP address of the multicast packet, the RPF check passes and the packet is forwarded ...