enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bridged and paralleled amplifiers - Wikipedia

   en.wikipedia.org/wiki/Bridged_and_paralleled...

   A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...

3. Bi-amping and tri-amping - Wikipedia

   en.wikipedia.org/wiki/Bi-amping_and_tri-amping

   A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range. Bi-amping of speakers requires double the channels of amplification and can be accomplished using two ordinary amplifiers in either a vertical or horizontal arrangement.

4. Sansui AU-11000 - Wikipedia

   en.wikipedia.org/wiki/Sansui_AU-11000

   The 2 circuits make up each power amplifier per channel. This makes a total of 8 power-output transistors within the amplifier. Each amplifier channel has a temperature sensor built-in as part of the power protection circuitry. If the amplifier is too hot, the power protection circuitry will not allow the amplifier to power on.

5. Amplifier - Wikipedia

   en.wikipedia.org/wiki/Amplifier

   Stereo amplifiers imply two channels of output (left and right), though the term simply means "solid" sound (referring to three-dimensional)—so quadraphonic stereo was used for amplifiers with four channels. 5.1 and 7.1 systems refer to Home theatre systems with 5 or 7 normal spatial channels, plus a subwoofer channel. Buffer amplifiers ...

6. Constant-voltage speaker system - Wikipedia

   en.wikipedia.org/wiki/Constant-voltage_speaker...

   The voltage is constant only in the sense that at full power, the voltage in the system does not depend on the number of speakers driven (as long the amplifier's maximum power is not exceeded). [2] Constant-voltage speaker systems are also commonly referred to as 25- , 70- , 70.7- , 100 or 210-volt speaker systems ; distributed speaker systems ...

7. Naim Audio amplification - Wikipedia

   en.wikipedia.org/wiki/Naim_Audio_amplification

   Naim power amplifiers are given numbers according to their power output into nominal load of 4 ohms. The company's first amplifier, the NAP 160, is a two-channel power amplifier with an output of 60 watts per channel; the NAP 135, which is a one-channel amplifier based on the same design as the NAP 250 rated at 135 watts. A custom-built very ...