Search results
Results from the WOW.Com Content Network
A hydrostatic test is a way in which pressure vessels such as pipelines, plumbing, gas cylinders, boilers and fuel tanks can be tested for strength and leaks. The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection , and pressurization of the vessel to the specified ...
Pressure head is a component of hydraulic head, in which it is combined with elevation head. When considering dynamic (flowing) systems, there is a third term needed: velocity head . Thus, the three terms of velocity head , elevation head , and pressure head appear in the head equation derived from the Bernoulli equation for incompressible fluids :
p is the hydrostatic pressure (Pa), ρ is the fluid density (kg/m 3), g is gravitational acceleration (m/s 2), z is the height (parallel to the direction of gravity) of the test area (m), 0 is the height of the zero reference point of the pressure (m) p_0 is the hydrostatic pressure field (Pa) along x and y at the zero reference point
Measuring hydraulic head in an artesian aquifer, where the water level is above the ground surface. Hydraulic head or piezometric head is a specific measurement of liquid pressure above a vertical datum. [1] [2] It is usually measured as a liquid surface elevation, expressed in units of length, at the entrance (or bottom) of a piezometer.
It works on the principle that the hydrostatic head of the "kill fluid" or "kill mud" will be enough to suppress the pressure of the formation fluids. Well kills may be planned in the case of advanced interventions such as workovers, or be contingency operations. The situation calling for a well kill will dictate the method taken.
The hydrostatic head is lowered and the fluid is gas lifted to the surface. Single-well alternate completions: in this instance there is a well with two zones. In order to produce from both the zones are isolated with packers. Blast joints may be used on the tubing within the region of the perforations.
Hydrostatic head is also used as a measure of the waterproofing of a fabric, commonly in clothing and equipment used for outdoor recreation.It is measured as a length (typically millimetres), representing the maximum height of a vertical column of water that could be placed on top of the fabric before water started seeping through the weave.
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid. TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.