Search results
Results from the WOW.Com Content Network
The average density of basalt is 2.9 g/cm 3, compared, for example, to granite’s typical density of 2.7 g/cm 3. [16] The viscosity of basaltic magma is relatively low—around 10 4 to 10 5 cP—similar to the viscosity of ketchup, but that is still several orders of magnitude higher than the viscosity of water, which is about 1 cP). [17]
The tholeiitic magma series (/ ˌ θ oʊ l eɪ ˈ ɪ t ɪ k /) is one of two main magma series in subalkaline igneous rocks, the other being the calc-alkaline series. A magma series is a chemically distinct range of magma compositions that describes the evolution of a mafic magma into a more evolved, silica rich end member.
The 'high' form can be produced from the 'low' form by heating above 750 °C (1,380 °F) [6] High albite can be found in meteor impact craters such as in Winslow, Arizona. [7] Upon further heating to more than 1,050 °C (1,920 °F) the crystal symmetry changes from triclinic to monoclinic ; this variant is also known as 'monalbite'. [ 8 ]
Ultramafic lava may have been detected on Io, a moon of Jupiter, because heat-mapping of Io's surface found ultra-hot areas with temperatures in excess of 1,200 °C (2,190 °F). The magma immediately below these hot spots is probably about 200 °C (360 °F) hotter, based on surface-to-subsurface temperature differences observed for lava on Earth.
Table of specific heat capacities at 25 °C (298 K) unless otherwise noted. [citation needed] Notable minima and maxima are shown in maroon. Substance Phase Isobaric mass heat capacity c P J⋅g −1 ⋅K −1 Molar heat capacity, C P,m and C V,m J⋅mol −1 ⋅K −1 Isobaric volumetric heat capacity C P,v J⋅cm −3 ⋅K −1 Isochoric ...
Viscosities can be relatively low, around 10 4 to 10 5 cP (10 to 100 Pa⋅s), although this is still many orders of magnitude higher than water. This viscosity is similar to that of ketchup. [30] Basalt lavas tend to produce low-profile shield volcanoes or flood basalts, because the fluidal
The melting temperature of dry granite at ambient pressure is 1215–1260 °C (2219–2300 °F); [13] it is strongly reduced in the presence of water, down to 650 °C at a few hundred megapascals of pressure. [14] Granite has poor primary permeability overall, but strong secondary permeability through cracks and fractures if they are present.
The density of quartz is around 2.65 g/cm 3 but the (dry) bulk density of a mineral soil is normally about half that density, between 1.0 and 1.6 g/cm 3. In contrast, soils rich in soil organic carbon and some friable clays tend to have lower bulk densities ( <1.0 g/cm 3 ) due to a combination of the low-density of the organic materials ...