Ads
related to: cat 5 crossover cable diagramcdw.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...
Category 5 cable that is partially stripped and showing its four twisted pairs (eight wires). Category 5 cable (Cat 5) is a twisted pair cable for computer networks.Since 2001, the variant commonly in use is the Category 5e specification (Cat 5e).
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
Common for current LANs. Superseded by Cat 5e, but most Cat 5 cables meet Cat 5e standards. [18] Limited to 100 m between equipment. Cat 5e: UTP, [18] F/UTP, U/FTP [19] 100 MHz [18] 1000BASE-T, 2.5GBASE-T [18] Enhanced Cat 5. Common for current LANs. Same construction as Cat 5, but with better testing standards. [18] Limited to 100 m between ...
A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs). Crossover cables are sometimes still used ...
Since common Category 5 cable has four pairs, it is possible to use the spare pairs (pins 4–5, 7–8) in 10- and 100-Mbit/s configurations for other purposes. The spare pairs may be used for power over Ethernet (PoE), for two plain old telephone service (POTS) lines, or for a second 10BASE-T or 100BASE-TX connection.
shielded or unshielded Cat5, Cat5e, Cat6 or Cat6A cables using 8P8C (RJ-45) modular connectors with straight-through T568A or T568B wiring (modular cables wired to T568A at one end and T568B on the other are more commonly referred to as crossover cables) qualified optical fiber cables for use with modular fiber optic spectroscopy equipment
Twisted pair Token Ring uses T568B pairs 1 and 3 (the same as T568A pairs 1 and 2), so a crossover cable to connect two Token Ring interfaces must swap these pairs, connecting pins 4, 5, 3, and 6 to 3, 6, 4, and 5 respectively. A T1 cable uses T568B pairs 1 and 2, so to connect two T1 CSU/DSU devices back-to-back requires a crossover cable that ...
Ads
related to: cat 5 crossover cable diagramcdw.com has been visited by 1M+ users in the past month