Search results
Results from the WOW.Com Content Network
BMW — DISA (DIfferenzierte SaugAnlage – "Differential Air Intake"), two stage: M42, M44, M54, N62TU, three stage: N52; DIVA (continuously variable length runners): N62, is the world's first continuously variable length intake manifold. [2] Citroën — XM 3,0 V6.24 (200 hp) used during 1991 to 1997, ZX Coupe 2.0 16v XU10J4 engine.
Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]
The graph above shows the intake runner pressure over 720 crank degrees of an engine with a 7-inch (180 mm) intake port/runner running at 4500 rpm, which is its torque peak (close to maximum cylinder filling and BMEP for this engine). The two pressure traces are taken from the valve end (blue) and the runner entrance (red).
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
The cylinder head intake and exhaust ports and intake and exhaust manifolds are shape optimized for better volumetric efficiency. Mitsubishi lowered the friction of the engine by including elastic grinding of the valve stems, adopting a high-efficiency shroud equipped plastic impeller in the water pump and using 0W-20 low-viscosity oil.
Fiat 875 cc two cylinder TwinAir engine featuring Multiair technology. MultiAir or Multiair is a hydraulically-actuated variable valve timing (VVT) and variable valve lift (VVL) engine technology enabling "cylinder by cylinder, stroke by stroke" [1] control of intake air directly via a gasoline engine's inlet valves.
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
For an automobile engine the components through which the air flows to the engine cylinders, are collectively known as an intake system [4] and may include the inlet port and valve. [5] An intake for a hydroelectric power plant is the capture area in a reservoir which feeds a pressure pipe, or penstock , or into an open canal.