Search results
Results from the WOW.Com Content Network
KryoFlux consists of a small hardware device, [4] [5] which is a software-programmable FDC system that runs on small ARM-based devices that connects to a floppy disk drive and a host PC over USB, and software for accessing the device. KryoFlux reads "flux transitions" from floppy disks at a very fine resolution. [6]
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
A floppy-disk controller (FDC) is a hardware component that directs and controls reading from and writing to a computer's floppy disk drive (FDD). It has evolved from a discrete set of components on one or more circuit boards to a special-purpose integrated circuit (IC or "chip") or a component thereof.
The floppy disk emulator can provide other systems access to the data on the emulated floppy in a number of ways: Direct access to some dedicated disk partition (e.g.: a 1.44MB partition on a USB key) Floppy file system translation (e.g.: FAT12 floppy ↔ USB key folder) Floppy disk images (e.g.: raw floppy ↔ .img/.iso USB key file)
FlashPath is hardware compatible with all standard 3.5" High-Density Floppy disk drives, but is not a drop-in replacement for real floppy disks. A special software device driver must be installed on the computer that is to access data via FlashPath. Thus, FlashPath is only usable with computers and operating systems for which such a driver ...
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
The "TIB 001" was a 3.5″ floppy drive that connected to the Commodore 64 via the expansion port, meaning that these drives were very fast. The floppy disks themselves relied on an MS-DOS disk format, and being based on cartridge allowed the Commodore 64 to boot from them automatically at start-up.
The turbo mode can be controlled by software, logical level on bus, or by an external button. KAY-1024/3SL/TURBO motherboard with three slots for additional devices: floppy disk controller, IDE drive, IBM PC keyboard, modem, etc (no soldering needed). Built-in hard drive support in ROM.