Search results
Results from the WOW.Com Content Network
Inside the wastegate actuator, a spring acts to open the wastegate, and oil pressure acts to close the wastegate. On the oil output side of the wastegate actuator sits the density controller, an air-controlled oil valve which senses upper deck pressure and controls how fast oil can bleed from the wastegate actuator back to the engine. As the ...
A 3-port solenoid-type boost controller A 4-port solenoid-type boost controller (used for a dual-port wastegate). The purpose of a boost controller is to reduce the boost pressure seen by the wastegate's reference port, in order to trick the wastegate into allowing higher boost pressures than it was designed for.
The starter motor is a series, compound, or permanent magnet type electric motor with a solenoid and solenoid operated switch mounted on it. When low-current power from the starting battery is applied to the starter solenoid, usually through a key-operated switch, the solenoid closes high-current contacts for the starter motor and it starts to ...
This design has a lower flow rate compared to VNT types so a wastegate may be incorporated with this design. [5] VGTs may be controlled by a membrane vacuum actuator, electric servo, 3-phase electric actuation, hydraulic actuator, or pneumatic actuator using air brake pressure. Unlike fixed-geometry turbines, VGTs do not require a wastegate. [6]
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.
A transmission solenoid or cylinoid is an electro-hydraulic valve that controls fluid flow into and throughout an automatic transmission. Solenoids can be normally open or normally closed. They operate via a voltage or current supplied by the transmission computer or controller.
The FICM (fuel injection control module) has been a problem, where low voltage in the vehicle's electrical system due to failing batteries or a low-output alternator can cause damage to the FICM. In addition, the placement of the FICM on top of the engine subjects it to varying and extreme temperatures and vibrations causing solder joints and ...
EGR valve the top of box on top of the inlet manifold of a Saab H engine in a 1987 Saab 90. In internal combustion engines, exhaust gas recirculation (EGR) is a nitrogen oxide (NO x) emissions reduction technique used in petrol/gasoline, diesel engines and some hydrogen engines. [1]