Search results
Results from the WOW.Com Content Network
In this example there are 1000 pulses per second (one kilohertz pulse rate) with a gated pulse width of 42 μs. The pulse packet frequency in this example is 27.125 MHz of RF energy. The duty cycle for a pulsed radio frequency is the percent time the RF packet is on, 4.2% for this example ([0.042 ms × 1000 pulses divided by 1000 ms/s] × 100).
Pulse-frequency modulation (PFM) is a modulation method for representing an analog signal using only two levels (1 and 0). It is analogous to pulse-width modulation (PWM), in which the magnitude of an analog signal is encoded in the duty cycle of a square wave .
Typically, these fences are 2.4 metres (7 ft 10 in) tall and send high voltage electric pulses through the palisade at a frequency of 1 Hz (one pulse per second). Palisade electric fences are used in most countries, particularly where there is little vegetation to short-circuit the fence or where the costs of security personnel are high in ...
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
A pulse per second (PPS or 1PPS) is an electrical signal that has a width of less than one second and a sharply rising or abruptly falling edge that accurately repeats once per second. PPS signals are output by radio beacons, frequency standards , other types of precision oscillators and some GPS receivers.
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.
A bandwidth-limited pulse (also known as Fourier-transform-limited pulse, or more commonly, transform-limited pulse) is a pulse of a wave that has the minimum possible duration for a given spectral bandwidth. Bandwidth-limited pulses have a constant phase across all frequencies making up the pulse.
The amount of energy that is returned to the radar receiver is a function of the peak energy of the pulse, the pulse width, and the pulse repetition frequency. Increasing the pulse width increases the amount of energy reflected off the target and thereby increases the range at which an object can be detected. Radars measure range based on the ...