enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Solvent bonding - Wikipedia

   en.wikipedia.org/wiki/Solvent_bonding

   Solvent bonding differs from adhesive bonding, because the solvent does not become a permanent addition to the joined substrate. [4] Solvent bonding differs from other plastic welding processes in that heating energy is generated by the chemical reaction between the solvent and thermoplastic, and cooling occurs during evaporation of the solvent ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   In contrast to a coupling requiring solvent welding, soldering, or rotation (for threaded couplings), a union allows easy connection and disconnection multiple times if needed. It consists of three parts: a nut, a female, and a male end. When the female and male ends are joined, the nut seals the joint by pressing the two ends tightly together.

4. Weld-On - Wikipedia

   en.wikipedia.org/wiki/Weld-On

   Weld-On is a division of IPS Corporation, a manufacturer of solvent cements, primers, and cleaners for PVC, CPVC, and ABS plastic piping systems. Weld-On products are commonly used for joining plastic pipes and fittings. Weld-On also manufactures specialty products from repair adhesives for leaking pipes, pipe thread sealants / joint compounds ...

5. Heat fusion - Wikipedia

   en.wikipedia.org/wiki/Heat_fusion

   Electrofusion is a method of joining HDPE and other plastic pipes with special fittings that have built-in resistive wire which is used to weld the joint together. The pipes to be joined are trimmed, cleaned, inserted into the electrofusion fitting (with a temporary clamp if required) and a voltage (typically 40V) is applied using a device ...

6. Plastic welding - Wikipedia

   en.wikipedia.org/wiki/Plastic_welding

   Hot gas welding, also known as hot air welding, is a plastic welding technique using heat. A specially designed heat gun, called a hot air welder, produces a jet of hot air that softens both the parts to be joined and a plastic filler rod, all of which must be of the same or a very similar plastic. (Welding PVC to acrylic is an exception to ...

7. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

8. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   A close nipple can only be unscrewed by gripping one threaded end with a pipe wrench which will damage the threads and necessitate replacing the nipple, or by using a specialty tool known as a nipple wrench (or known as an internal pipe wrench) which grips the inside of the pipe, leaving the threads undamaged. When the ends are of two different ...

9. Plastic cement - Wikipedia

   en.wikipedia.org/wiki/Plastic_cement

   Plastic Cement may refer to: Cement, in the US where it refers to certain formulations of Masonry Cement; Dichloromethane, used to solvent weld some thermoplastics including acrylic; Butanone, model cement is a thick mixture with polystyrene; Tetrahydrofuran, the main solvent in PVC cement