Search results
Results from the WOW.Com Content Network
The vertical stabilizer is the fixed vertical surface of the empennage. A vertical stabilizer or tail fin [1] [2] is the static part of the vertical tail of an aircraft. [1] The term is commonly applied to the assembly of both this fixed surface and one or more movable rudders hinged to it. Their role is to provide control, stability and trim ...
A yaw damper (sometimes referred to as a stability augmentation system [1]) is a system used to reduce (or damp) the undesirable tendencies of an aircraft to oscillate in a repetitive rolling and yawing motion, a phenomenon known as the Dutch roll.
A Boeing 737 uses an adjustable stabilizer, moved by a jackscrew, to provide the required pitch trim forces. Generic stabilizer illustrated. A horizontal stabilizer is used to maintain the aircraft in longitudinal balance, or trim: [3] it exerts a vertical force at a distance so the summation of pitch moments about the center of gravity is zero. [4]
The rudder is typically mounted on the trailing edge of the vertical stabilizer, part of the empennage. When the pilot pushes the left pedal, the rudder deflects left. Pushing the right pedal causes the rudder to deflect right. Deflecting the rudder right pushes the tail left and causes the nose to yaw to the right.
The horizontal stabilizer is the fixed horizontal surface of the empennage. A tailplane, also known as a horizontal stabilizer, is a small lifting surface located on the tail behind the main lifting surfaces of a fixed-wing aircraft as well as other non-fixed-wing aircraft such as helicopters and gyroplanes. Not all fixed-wing aircraft have ...
The elevator is a usable up and down system that controls the plane, horizontal stabilizer usually creates a downward force which balances the nose down moment created by the wing lift force, which typically applies at a point (the wing center of lift) situated aft of the airplane's center of gravity.
An animated illustration of the two motions which combine into a Dutch roll Dutch roll damping technique, scanned from U.S. Air Force flight manual. Dutch roll is an aircraft motion consisting of an out-of-phase combination of "tail-wagging" (yaw) and rocking from side to side (roll).
Examples of sideforce-generating surfaces are the vertical stabilizer, rudder, and parts of the fuselage. When an aircraft is in a sideslip, these surfaces generate sidewards lift forces. If the surface is above or below the center of gravity, the sidewards forces generate a rolling moment. This rolling moment caused by sideslip is dihedral ...