Search results
Results from the WOW.Com Content Network
The modern toilet utilises a cistern to reserve and hold the correct amount of water required to flush the toilet bowl. In earlier toilets, the cistern was located high above the toilet bowl and connected to it by a long pipe. It was necessary to pull a hanging chain connected to a release valve located inside the cistern in order to flush the ...
Twin Peaks Reservoir, at near-empty level. The Twin Peaks Reservoir is the backbone of the AWSS system and is located at the top of San Francisco's Twin Peaks hilltop. It is made up of a 10.5-million-U.S.-gallon (40-million-liter) storage reservoir made out of 6-inch-thick (150 mm) reinforced-concrete slabs.
The toilet has two buttons on the cistern rather than the single-flush one; one button delivers a lesser amount of water (eg. 3 litres) and the other a greater amount (eg. 6 litres). [7] It also uses a larger 10 cm trapway in the bowl, allowing for water to come out faster and clear the bowl efficiently.
The flushing trough was developed by Adamsez Limited and a patent was issued to MJ Adams in 1912 for a flushing trough that used the bell siphon flushing system. [1] A further patent was issued in 1928 to AH Adams for a flushing trough that used the plate siphon mechanism, [2] marketed as the 'Epic'.
If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...
Craigslist headquarters in the Inner Sunset District of San Francisco prior to 2010. The site serves more than 20 billion [17] page views per month, putting it in 72nd place overall among websites worldwide and 11th place overall among websites in the United States (per Alexa.com on June 28, 2016), with more than 49.4 million unique monthly visitors in the United States alone (per Compete.com ...
Location photo and close-up shot of a toilet rim block in its holder. A toilet rim block is a substance in the shape of a block that is used in flush toilets, which slowly dissolves in water. The blocks usually come in a small holder that is attached over the rim of a toilet and hangs down into the bowl, so as the toilet gets flushed, the water ...
A typical flush toilet is a ceramic bowl (pan) connected on the "up" side to a cistern (tank) that enables rapid filling with water, and on the "down" side to a drain pipe that removes the effluent. When a toilet is flushed, the sewage should flow into a septic tank or into a system connected to a sewage treatment plant .