Search results
Results from the WOW.Com Content Network
6061-T6 aluminium standard heat treating process. T6 temper 6061 has been treated to provide the maximum precipitation hardening (and therefore maximum yield strength) for a 6061 aluminium alloy. It has an ultimate tensile strength of at least 290 MPa (42 ksi) and yield strength of at least 240 MPa (35 ksi).
The following is a list of countries by raw aluminium exports. Data is for 2021, in millions of United States dollars, as reported by The Observatory of Economic Complexity. Currently the top ten countries are listed.
This is a list of prices of chemical elements. Listed here are mainly average market prices for bulk trade of commodities. Listed here are mainly average market prices for bulk trade of commodities. Data on elements' abundance in Earth's crust is added for comparison.
The contracts prices are quoted in US dollars per tonne. LME prices have minimum tick sizes of $0.50 per tonne (or $12.50 for one contract) for open outcry trading in the LME Ring and electronic trading on LMEselect, while minimum tick sizes are reduced for inter-office telephone trading to $0.01 per tonne (or $0.50 for one contract).
In addition, there is the phase before the for the Aluminium-copper alloys are typical. Alloys with higher copper content (alloyings 6061, 6056, 6013) are mainly used in aviation. Iron occurs in all aluminium alloys as an impurity in quantities of 0.05-0.5%.
This is a list of countries by primary aluminium production in 2023. [1] Primary aluminium is produced from aluminium oxide which is obtained from bauxite and excludes recycled aluminium. Only countries with a minimum production of 100,000 tonnes are listed.
Aluminum can prices vary by region and are based on weight. The average recycling value per pound of cans in the U.S. is currently $0.56. How many aluminum cans are in a pound?
Of course, cost per kg is not the only important factor in material selection. An important concept is 'cost per unit of function'. For example, if the key design objective was the stiffness of a plate of the material, as described in the introductory paragraph above, then the designer would need a material with the optimal combination of ...