enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oil pressure - Wikipedia

   en.wikipedia.org/wiki/Oil_pressure

   Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...

3. Motor oil - Wikipedia

   en.wikipedia.org/wiki/Motor_oil

   An oil pump, a vane or gear pump powered by the engine, pumps the oil throughout the engine, including the oil filter. Oil filters can be a full flow or bypass type. In the crankcase of a vehicle engine, motor oil lubricates rotating or sliding surfaces between the crankshaft journal bearings (main bearings and big-end bearings) and rods ...

4. Oil pump (internal combustion engine) - Wikipedia

   en.wikipedia.org/wiki/Oil_pump_(internal...

   The oil pump is an internal combustion engine part that circulates engine oil under pressure to the rotating bearings, the sliding pistons and the camshaft of the engine. This lubricates the bearings, allows the use of higher-capacity fluid bearings and also assists in cooling the engine.

5. MAP sensor - Wikipedia

   en.wikipedia.org/wiki/MAP_sensor

   Engine vacuum is the difference between the pressures in the intake manifold and ambient atmospheric pressure. Engine vacuum is a "gauge" pressure, since gauges by nature measure a pressure difference, not an absolute pressure. The engine fundamentally responds to air mass, not vacuum, and absolute pressure is necessary to calculate mass.

6. OBD-II PIDs - Wikipedia

   en.wikipedia.org/wiki/OBD-II_PIDs

   OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.

7. Leak-down tester - Wikipedia

   en.wikipedia.org/wiki/Leak-down_tester

   Testing is done on an engine which is not running, and normally with the tested cylinder at top dead center on compression, although testing can be done at other points in the compression and power stroke. Pressure is fed into a cylinder via the spark plug hole and the flow, which represents any leakage from the cylinder, is measured. Leak-down ...