Ad
related to: bipolar constant current source
Search results
Results from the WOW.Com Content Network
Figure 1: A version of the Widlar current source using bipolar transistors. Figure 1 is an example Widlar current source using bipolar transistors, where the emitter resistance R 2 is connected to the output transistor Q 2, and has the effect of reducing the current in Q 2 relative to Q 1.
Conversely, a current source provides a constant current, as long as the impedance of the load is sufficiently lower than the current source's parallel impedance (which is preferably very high and ideally infinite). In the case of transistor current sources, impedances of a few megohms (at low frequencies) are typical. Because power is current ...
A current mirror is a circuit designed to copy a current through one active device by controlling the current in another active device of a circuit, keeping the output current constant regardless of loading. The current being "copied" can be, and sometimes is, a varying signal current.
This is the only first order source of mismatch in the three-transistor Wilson current mirror [8] Second, at high currents the current gain, β, of transistors decreases and the relation of collector current to base-emitter voltage deviates from = (). The severity of these effects depends on the collector voltage.
3D model of a TO-92 package, commonly used for small bipolar transistors. A bipolar junction transistor (BJT) is a type of transistor that uses both electrons and electron holes as charge carriers. In contrast, a unipolar transistor, such as a field-effect transistor (FET), uses only one kind of charge carrier.
The "long-tail" current source (R E) sets the total current flowing through the two legs of the pair. The input voltage controls the current flowing through the transistors by sharing it between the two legs, steering it all to one side when not near the switching point.
A bipolar junction transistor can be modeled as a dependent current source whose magnitude depends on the magnitude of the current fed into its controlling base terminal. An operational amplifier can be described as a voltage source dependent on the differential input voltage between its input terminals. [ 1 ]
It is known as a current-limiting diode (CLD) or current-regulating diode (CRD). Internal structure. It consists of an n-channel JFET with the gate shorted to the source, which functions like a two-terminal current limiter (analogous to a voltage-limiting Zener diode). It allows a current through it to rise to a certain value, but not higher.
Ad
related to: bipolar constant current source