Search results
Results from the WOW.Com Content Network
Air pollution sensor; Analog image processing; Atomic force microscopy; Atomic Gravitational Wave Interferometric Sensor; Attitude control (spacecraft): Horizon sensor, Earth sensor, Moon sensor, Satellite Sensor, Sun sensor; Catadioptric sensor; Chemoreceptor; Compressive sensing; Cryogenic particle detectors; Dew warning; Diffusion tensor ...
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter.
A direct TPMS sensor consists of the following main functions requiring only a few external components — e.g. battery, housing, PCB — to get the sensor module that is mounted to the valve stem inside the tire: pressure sensor; analog-digital converter; microcontroller; system controller; oscillator; radio frequency transmitter;