Search results
Results from the WOW.Com Content Network
Helical involute gears are typically only used in limited situations where the spirals of the teeth are of the same handedness, the spirals of the two involutes are of different handedness, and the line of action is the external tangents to the base circles (analogous to a normal belt drive, whereas normal gears are analogous to a crossed-belt ...
Involute spline where the sides of the equally spaced grooves are involute, as with an involute gear, but not as tall. The curves increase strength by decreasing stress concentrations. Crowned splines where the sides of the equally spaced grooves are usually involute, but the male teeth are modified to allow for misalignment. Serrations
Form diameter is the diameter of a circle at which the trochoid (fillet curve) produced by the tooling intersects, or joins, the involute or specified profile. Although these terms are not preferred, it is also known as the true involute form diameter (TIF), start of involute diameter (SOI), or when undercut exists, as the undercut diameter.
Pressure angles. Pressure angle in relation to gear teeth, also known as the angle of obliquity, [1] is the angle between the tooth face and the gear wheel tangent. It is more precisely the angle at a pitch point between the line of pressure (which is normal to the tooth surface) and the plane tangent to the pitch surface.
It is a constant distance in any helical involute gear. Transverse base pitch, p b, p bt In an involute gear, the pitch is on the base circle or along the line of action. Corresponding sides of involute gear teeth are parallel curves, and the base pitch is the constant and fundamental distance between them along a common normal in a transverse ...
This has replaced hobbing for some involute gears and cutting external splines and slots. [9] Straddle broaches use two slab broaches to cut parallel surfaces on opposite sides of a workpiece in one pass. This type of broaching holds closer tolerances than if the two cuts were done independently. [9]
Involute splines based on reference diameters – Part 1: Generalities: Active: DIN 5480-2: Involute splines based on reference diameters – Part 2: Nominal and inspection dimensions: Active: DIN 5480-15: Involute splines based on reference diameters – Part 15: Inspection: Active: DIN 5483-1: Time-dependent quantities – Part 1: Terms for ...
For example, if there are 202 teeth on the circular spline and 200 on the flex spline, the reduction ratio is (200 − 202)/200 = −0.01 Thus the flex spline spins at 1/100 the speed of the wave generator plug and in the opposite direction. Different reduction ratios are set by changing the number of teeth.